With textile covering
Textile coverings include cut pile carpet, needle felt and ball yarn
Floor panels in many styles
Discover our great selection of floor panels. All the floor panels of the same type are interchangeable. Thanks to bevelled machined edges it is easy to lift and insert them.
The elastic and impact resistant edge made of hard synthetic material provides good protection against mechanical damage. The coating of the lower side with aluminium foil protects the panel against moisture absorption. For more demanding static requirements we cover the lower side or the upper side with a galvanized steel plate. For electro-conductive coatings the conduction of electrical current is ensured in accordance with the requirements of standard EN 1081.
Special panels made of steel, aluminium and wood cement as well as special formats on request.
The right floor panels for every need
Access floor panels with covering – High density chipboard
Access floor panels made of high density chipboard with covering applied at the factory
With hard covering
Hard covering materials include synthetics, linoleum, rubber and laminate.
Access floor panels with covering – Calcium sulphate
Access floor panels without covering – High density chipboard and calcium sulphate
Access floor thin panels – High density chipboard
Access floors thin panels – Calcium sulphate
Access floor panels with parquet covering
The type and manufacture of the parquet determine the format and construction of the access floor panels. We use a beige edge for lighter woods (oak, maple) and an anthracite edge for darker woods (stained oak, exotic woods).
Solid parquet consists of small-format wooden strips 8 mm thick, which are put together to form a pattern: parallel or English. The surface is sealed or oiled at the factory.
The format of the strips of 160 x 23 mm provides a base size of the panel of 640 x 640 mm. As a finished format of 600 x 600 to 635 x 635 mm is possible. For formats 600 x 600 mm the strips are a bit shorter at the edge of the panel.
Access floor panels with parquet covering – Ready-made parquet
2-layer strip parquet
Two-layer parquet consists of a top layer of 4 to 6 mm and a carrier layer. The total thickness is 10 to 12 mm. The individual strips are put together into a pattern: parallel, English or shipdeck. The parquet manufacturer already seals or oils the upper surface.
The format of the strips should result in a base size of 605 x 605 to 630 x 630 mm for the panels, which results in a finished size of 600 x 600 mm.
3-layer strip parquet
Three-layer parquet consists of a top layer of approx. 4 mm, a middle layer and a barrier layer with a total thickness of 14 mm. The strips are put together into a shipdeck pattern. The upper surface is delivered already sealed or oiled by the parquet manufacturer.
The format of the planks of 2200 x 205 mm results in a base size of the panel of 615 x 615 mm and a finished size of 600 x 600 mm.